Dometic REFRIGERATION 9 serie Montageanleitung Seite 16

Safety instructions
• This device may only be repaired by qualified personnel. Inadequate
repairs may cause serious hazards.
• Only use propane or butane gas (not natural gas).
• Always operate the device at the pressure shown on the type plate.
Use a DIN-DVGW-approved pressure regulator with a fixed setting in
accordance with DIN EN 12864.
• Dismantle all doors for the disposal of the old device and leave the
shelves in the device to prevent accidental enclosure and suffocation.
!
CAUTION!
• Danger of crushing! Do not put your fingers into the hinge.
• Before starting the device, ensure that the power supply line and the
plug are dry.
A
NOTICE!
• Only hold the device at the body of the refrigerator during transport.
Never hold the device on the oven, the cooling fins, the gas pipes, the
door or the control panel.
• Make sure that the refrigerator circuit is not damaged during transpor-
tation. The refrigerant in the refrigerator circuit is highly flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
• Do not install the device near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
• Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
• Check that the voltage specification on the type plate is the same as
that of the power supply.
• Do not open the refrigerant circuit under any circumstances.
• Only use the AC connection cable supplied to connect the device to
the AC mains.
• Only use cables with a suitable size.
• Never pull the plug out of the socket by the connection cable.
• The device may not be exposed to rain.
16
RMLT9xxx
EN