Nolan N70-2 GT Sicherheit Und Gebrauchsanleitung Seite 23

rials might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended to make sure the VPS is not touching other materials.
3 DISASSEMBLING THE VPS
3.1 Open the helmet visor and lower the VPS completely (see instructions above).
3.2 Hold the left side part of the sunscreen and pull it toward the outside of the helmet
(Fig. 16).
3.3 Repeat the same operation on the right side of the helmet.
4 ASSEMBLING THE VPS
4.1 Open the helmet visor completely and move the side slider up to the end-stop (see
instructions above) (Fig.14).
4.2 Insert the left end of the sunscreen into the left side guide until it is engaged in the
seat of the shell (Fig.16).
4.3 Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by activating and deactivating the side
slider (see instructions above).
If necessary, repeat the above-mentioned operations.
- If the VPS opening and closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolangroup authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
1 DISASSEMBLING THE INNER COMFORT PADDING
To disassemble the inner comfort padding, lift the VPS, open the visor completely and
remove the chin guard from the helmet (see instructions above).
1.1 Open the chin strap (see specific instructions), remove the left front roll neck flap
from the cheek pad; pull the front part of the left cheek pad towards the inside of
the helmet to release the snap fastener located on the left frame (Fig.17). Repeat
the same operation on the right side of the helmet.
1.2 Release the roll neck left eyelet from the left frame (Fig.18). Repeat the same op-
eration on the right side of the helmet.
1.3 Release the left rear flap of the liner from the shell edge by slightly puling the com-
fort padding towards the inside of the helmet (Fig.19). Then repeat the operation
with the central flaps and with the right flap too.
1.4 Hold the left front part of the liner and pull it upwards in order to remove the cor-
responding liner flap from the support fixed to the polystyrene inner shell (Fig.20).
Then repeat the operation with the central front flap and with right flap.
1.5 Remove left and right side flaps of the comfort padding from the cavities between
the inner polystyrene cheek pads and the outer shell (Fig.21).
1.6 Remove the chin straps from the liner (Fig.22).
1.7 Completely remove the liner from the helmet.
N70-2 GT
23
INSTRUCTIONS FOR USE