Maintenance And Cleaning - Nolan N70-2 GT Sicherheit Und Gebrauchsanleitung

N70-2 GT
CONGRATULATIONS on the purchase of your new helmet.
This helmet has been designed and created to be a modern, high performing product, able to satisfy the
most demanding requests as for safety and comfort. This is made possible by the helmet design, its ergo-
nomic, comfort and aerodynamic properties as well as its practical and easy-to-use controls.
SAFETY AND INSTRUCTIONS FOR USE
IMPORTANT
- Before using the helmet read this booklet and all enclosed documents carefully, in that they
contain very important indications on how to use the helmet easily and safely. We recommend
you to store it for future reference.
- Failure to observe these instructions may reduce the protection provided by the helmet and
consequently put your safety at risk.
- Do not operate or act in such a way that could compromise or reduce the protection provided
by the helmet.
USING THE HELMET
- The helmet is specifically designed for motorcycle and motorbike use. Therefore, it must not be
used for different purposes (or different reasons or operations) since, in such cases, it would not
guarantee the same protection.
- In case of accident, the helmet represents a protective element, which reduces injuries and head
damage.
Nevertheless, no helmet can guarantee total safety. The helmet reduces the risk or gravity of injuries
in case of accidents, but the degree of impacts and the different circumstances may exceed helmet
protection. Therefore, ride safely.
- When riding any motorcycle, always wear the helmet properly fastened in order to fully exploit its
protection.
- Never wear scarves under the fastening system nor caps of any sort under the helmet.
- The helmet can muffle traffic noises. However make sure that you can hear essential sounds such as
horns and emergency vehicle sirens.
- Always keep the helmet away from heat sources like the exhaust muffler, the bag seat or the interior
of a vehicle.
- Do not modify nor tamper with the helmet (or part of it) for any reason whatsoever. Any modification
and/or change compromise safety requirements and the protection degree of the helmet. The helmet
may be no more compliant to homologation standards and therefore could not be used anymore,
thus guarantee will be void.
- Use only original accessories and/or spare parts suitable for your specific helmet model.
- Damage resulting from accidental fall may not be visible, or not visible with the naked eye; helmets
which received impacts are to be replaced. Always handle your helmet carefully in order not to com-
promise or reduce its protection degree.
- In case of doubt about the helmet integrity and safety, avoid using it and contact an authorized
dealer to let it check.
CHOOSING THE HELMET
1 SIZE
1.1 In order to determine the correct helmet size, try on helmets of different sizes and choose the one
which suits best the shape of your head and which you feel firm once worn and fastened, thus en-
suring a great comfort.
1.2 Should the helmet be too big, it may slide down covering the eyes or turn slowly to the side while
riding.
1.3 Keep it on for a few minutes and make sure there are no points of extreme pressure that may cause
pain or headache.
16
SAFETY AND INSTRUCTIONS FOR USE
2 TAKING OFF THE HELMET
2.1 With the helmet on and the strap securely faste
figure (A). In case of accident the different force
result in helmet rotations or they may even cau
fastened.
2.2 The helmet should not rotate nor move on the
contrary happen, adjust strap length or change
3 RETENTION SYSTEM
3.1 The retention system (strap) is factory-adjuste
correctly pre-adjusted.
3.2 Make sure the strap is properly fastened and
Anyway, before riding, make sure that the strap
to the throat, but without being uncomfortable.
3.3 The correct strap tension should allow norma
space of a finger between strap and throat.
WARNING
The button which may be present on the s
strap has been fastened properly.
VISOR
- If the visor is damaged or deeply scratched cau
treatment is probably damaged so the visor is t
- The visor can be used for the intended helmet m
- Do not paint nor apply stickers.

MAINTENANCE AND CLEANING

WARNING
Helmet and visor may be seriously damaged
age being however visible. Use only lukewar
and then let them dry at room temperature a
WARNING
Never use petrol, thinner, benzene, solvents
- Irreparably damage the helmet;
- Modify optical properties, reduce mechanical o