Nolan N70-2 GT Sicherheit Und Gebrauchsanleitung Seite 19

Should you buy the visor as an accessory/spare part, we kindly request you to check
the correct size of the visor from a Nolangroup authorised dealer.
1 DISASSEMBLING THE VISOR
1.1 Open the visor completely (Fig.5).
1.2 Push the release lever of the left side mechanism completely upwards (Fig.6) and
then push the visor away from the helmet (Fig.7).
1.3 Disengage the release lever so that it returns downwards, to its initial position.
1.4 Follow the previous operations on the right side of the helmet.
2 ASSEMBLING THE VISOR
2.1 Place the left side of the visor on the corresponding side mechanism centring the
side hole of the visor on the mechanism (Fig.8).
2.2 Push the release lever of the mechanism completely upwards and, subsequently,
push the visor against the mechanism (Fig.6,7).
2.3 Disengage the release lever so that it returns downwards, to its initial position.
Then ensure that the visor remains engaged to the mechanism by pulling it out-
wards.
2.4 Follow the previous operations on the right side of the helmet.
2.5 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure that the mechanisms hold it in the different positions. If necessary,
repeat the above-mentioned operations.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
SIDE INSERTS OF THE VISOR AND VISOR AIR INTAKE
The visor features the presence of side inserts and an air intake which can be removed
from the latter to facilitate normal maintenance and cleaning operations.
1 DISASSEMBLING THE SIDE INSERTS OF THE VISOR AND VISOR AIR INTAKE
1.1 Remove the visor from the helmet (see instructions above).
1.2 Release the left side insert from the visor by pushing outwards at the three en-
gagement elastic click-on positions (Fig.9). Repeat the same operation on the right
side of the helmet.
1.3 Remove the visor air intake by first releasing the internal air diffuser "A" and then
removing the intake external part "B" from the hole provided in the visor(Fig.10).
2 ASSEMBLING THE SIDE INSERTS OF THE VISOR AND VISOR AIR INTAKE
2.1 Engage the left-hand side insert to the visor by pushing inwards at the three en-
gagement elastic click-on positions (Fig.9). Repeat the same operation on the right
side of the helmet.
N70-2 GT
19
INSTRUCTIONS FOR USE