Cleaning And Maintenance - Nevadent NAZ 2.4 C3 Bedienungsanleitung

6) Begin in one quadrant:
Start with the brush head 1 on your gums, and move the brush upwards/
downwards from the gums to the crown of the tooth .
Continue in this manner on both the inside and the outside of the tooth . Start
again on the gums for each individual tooth .
Do not forget the back surfaces of the rear molars .
To clean the chewing surfaces, guide the brush over the chewing surfaces
with a little pressure .
7) After 30 seconds, the toothbrush stops briefly to signal that you should
start cleaning the next quadrant . Clean all jaw quadrants using the same
technique .
8) After two minutes, the toothbrush stops briefly 3 times . This means that you
have complied with the dental recommendation of two minutes cleaning .
9) Press the On/Off switch 3 .
10) Then take the toothbrush out of your mouth .
11) After use, clean the brush head 1 thoroughly under running water .
12) Remove the brush head 1 from the handset .
To clean the drive shaft 2 and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft 2 is pointing
downwards at an angle .
NOTE
Massage your gums regularly . This promotes blood circulation and helps to
keep them healthy . Set the mode to "Massage" and guide the moistened brush
over your gums with a light pressure .

Cleaning and maintenance

DANGER – RISK OF ELECTRIC SHOCK!
► Always remove the plug from the charger 8 before cleaning the appliance!
Do not immerse the handset or the charger 8 in water or other liquids!
CAUTION – PROPERTY DAMAGE!
► Do not use detergents or solvents . They can damage the plastic surfaces .
NOTE
NEVER open the housing of the charger 8 or the toothbrush! They cannot be
resealed in a watertight manner .
NAZ 2.4 C3 GB │ IE │ NI │ CY │ 9 ■