Specifications - Makita DHS680 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Button
1-2. Red indicator
1-3. Battery cartridge
2-1. Switch trigger
2-2. Lock-off lever
3-1. Battery indicator
4-1. Mode indicator
5-1. Lever
5-2. Depth guide
6-1. Front lever
7-1. Stopper
8-1. Cutting line (0 ﾟ position)
8-2. Cutting line (45 ﾟ position)
8-3. Screw
9-1. Lamp
10-1. Hook
10-2. Close
10-3. Open
11-1. Hex wrench

SPECIFICATIONS

Max. cutting depth
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
11-2. Shaft lock
11-3. Tighten
11-4. Loosen
12-1. Inner flange
12-2. Saw blade
12-3. Outer flange
12-4. Hex bolt
13-1. Mounting shaft
13-2. Inner flange
13-3. Saw blade
13-4. Outer flange
13-5. Hex bolt
14-1. Mounting shaft
14-2. Inner flange
14-3. Saw blade
14-4. Outer flange
14-5. Hex bolt
15-1. Mounting shaft
15-2. Inner flange
Model
Blade diameter
at 0°
at 45°
at 50°
No load speed
Overall length
Net weight
Rated voltage
noise level determined
) : 83 dB (A)
pA
) : 94 dB (A)
WA
ENE078-2
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
ENG905-1
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
4
15-3. Saw blade
15-4. Outer flange
15-5. Hex bolt
15-6. Ring
16-1. Hex wrench
17-1. Dust nozzle
17-2. Screw
18-1. Vacuum cleaner
18-2. Hose
20-1. Clamping screw
20-2. Rip fence (Guide rule)
21-1. Adjusting screw for 45 ﾟ
21-2. Adjusting screw for 0 ﾟ
22-1. Triangular rule
23-1. Bevel guide
23-2. Screw
23-3. Guide
DHS680
165 mm
57 mm
41 mm
37 mm
-1
5,000 min
350 mm
3.3 kg
D.C. 18 V
total value (tri-axial
2
) : 2.5 m/s
h,W
2
ENG900-1
vector sum)
or less
ENG901-1