Connections In "Dmx" Mode; Connections In "Master / Slave" Mode - involight SlimPAR766 Bedienungsanleitung

110-119
120-129
130-139
140-149
150-159
160-169
170-179
180-189
190-255
0-9
10-69
CH10 70-129
130-189
190-255

3.5 Connections in "DMX" mode:

DMX is the abbreviation for digital multiplex and allows the digital control of several DMX devices via a common
control cable.
Connect the DMX input of the unit to the DMX output of a DMX controller or other DMX device. Connect the output
of the first DMX device to the input of the second and so on to form a series circuit
DMX connectors:
A three-pin XLR socket serves as a DMX output, a three-pin XLR connector serves as a DMX input.
For installations with very long DMX cable paths or high electrical interference, such as in a discotheque, it is
recommended to use a DMX terminator. The DMX terminator is connected in an XLR connector as a 120 Ω
resistor between pins 2 and 3, which is plugged into the last output socket of the DMX line.

3.6 Connections in "Master / Slave" mode:

When you configure a group of devices in the "Master / Slave" mode, the first device controls the others and
allows an automatic or music-controlled and synchronized show. This feature is especially useful for starting a
show without great programming. Connect the DMX output of the master device to the DMX input of the first slave
device. Then, connect the DMX output of the first slave device to the DMX input of the second slave device, and
so on.
"Slave" mode: Can be set via IR remote control
Green yellow
Salmon
Turquoise
Light Green
Orange
Lavender
Light blue
Dark blue
Pink
No Function
Colour fading from slow to fast
Colour change from slow to fast
Colour fading in sound mode from slow to fast
Colour change in the sound mode from slow to fast
26