Henry Schein HS Gebrauchsanweisung Seite 12

designed to provide reasonable protection against
harmful interference in a typical medical installation.
2 Sensor LED light emissions fall within Class 1 level,
according to IEC/EN 60825-1:2001. No special safety
precautions are required.
3 Normal operation means:
 The oximeter is turned on;
 A sensor is connected to the oximeter;
 The sensor is applied to the patient;
 The patient's SpO2, Pulse rate are being
reported;
 No error conditions exist.
4 Wash the probe with clean water after disinfecting it to
remove any remaining solution. The probe can only be
reused after dried thoroughly.
5 Do not disinfect the probe with the water boiled.
6 Any residue should be removed from the probe before
being disinfected, and avoid contacting corrosive
solvent. Dipping the cable into alcohol or alkalescent
solvent for a long time may reduce the flexibility of the
scarfskin of the cable. Also, the connector should not be
dipped.
7 After monitoring, disinfect the probe according to the
instruction described in the user manual.
8 The materials with which the patient or any other person
can come into contact conform with the standard of
ISO10993.
9 The pictures and interfaces in this manual are for
reference only.
10 A functional tester cannot be used to assess the
accuracy of the oximeter probe or the oximeter.
11 The operating time of the Ni-MH rechargeable battery
package depends on the configuration and operation of
the pulse oximeter.
11