Charging The Battery; Handling And Operation; Switching On/Off And Setting The Speed - Silvercrest SVT 3.7 A1 Bedienungsanleitung

Charging the battery

Before using the fan, the integrated battery must be charged. When using a USB
mains adapter, the fan can also be used during charging. If the fan is being charged
via a USB port on a PC or notebook, simultaneous use is not recommended due
to the high power consumption. Make sure that at least two additional USB ports
remain free to prevent damage to the PC or notebook.
CAUTION
► Charge the battery only in dry indoor areas.
► If you do not want to use the appliance right away, remove the charging cable
after charging has been completed.
♦ Connect the USB-A plug of the charging cable
supply (5 V/1.5 A, not included) or a USB port on a PC or notebook.
♦ Connect the micro USB plug of the charging cable
port on the fan. The operating LED
soon as the operating LED
NOTE
► If the operating LED
battery is exhausted and must be charged.

Handling and operation

Switching on/off and setting the speed
♦ Press the
♦ Press the
(low, medium, high).
♦ Press the
The operating LED
■ 18 │ GB │ IE │ NI
goes out, the integrated battery is fully charged.
flashes blue while the fan is in use, the integrated
button to turn on the fan. The operating LED
button repeatedly to switch between the three speed levels
button again to turn off the fan.
goes out.
to a suitable USB power
to the micro USB charging
lights up orange during charging. As
lights up blue.
SVT 3.7 A1