Frost Protection Function; Use The Heating Fan Only; Care And Cleaning; Storage - Silvercrest SOR 2400 D2 Bedienungs- Und Sicherheitshinweise

Turn the temperature control
the heat level switch
Remove the mains plug from the mains
socket.

Frost protection function

The frost protection function
automatically controls the product to
keep the room temperature above
7 °C, steps are as follows:
Connect the product to an earthed socket
protected by a residual current circuit
breaker.
Switch on the product by setting the heat
level switch to either "1", "2" or "3" and
2
by setting the temperature control
"MIN". The product switches on when the
room temperature is approx. 7 °C. As soon
as the room temperature is above 7 °C, the
product automatically switches off again.
Note: The product will switch itself on and
off automatically to maintain a temperature
higher than 7 °C.

Use the heating fan only

To use the hot air outlet
product, steps are as follows.
Connect the product to an earthed socket
protected by a residual current circuit
breaker.
Press the heating fan switch
"I" to switch on the hot air outlet
indicator in the heating fan switch
light up. Hot air will be blown through the hot
air outlet .
5
To switch off the hot air outlet
heating fan switch

Care and cleaning

Let the product to cool down
before cleaning.
to MIN and
3
to "0".
2
to
3
only on the
5
to position
4
. An
5
will
4
, press the
5
to "0" position.
4
Never immerse the product,
power cord or mains plug into water.
Remove the mains plug from the mains socket
and leave the product to cool completely
before cleaning.
Use a damp lint-free cloth to clean the product.
Use a mild detergent on the cloth for
stubborn dirt.
Do not use abrasive, aggressive or chemical
cleaning agents. It could damage the surfaces
of the product.

Storage

If the product not to be use for a long period
of time, clean it as described in the section
"Care and Cleaning".
Wind the power cord around the power cord
retainer clockwise tightly and let the
7
mains plug being held at the upper part of
power cord retainer
7
Store the product at a clean and dry location.
, see fig D.
GB/IE 21