Safety Notes - Grohe EUROECO COSMOPOLITAN E series Montageanleitung

GB

Safety notes

Prevent danger resulting from damaged voltage
supply cables.
If damaged, the voltage supply cable must be
replaced by the manufacturer or his customer service
department or an equally qualified person.
• Installation is only possible in frost-free rooms.
• The plug-in voltage supply is only suitable for indoor use.
• The plug-in connectors must not be directly or indirectly
sprayed with water when cleaning.
• Use only genuine replacement parts and accessories.
The use of other parts will result in voiding of the warranty
and the CE identification, and could lead to injuries.
Technical data
• Flow rate at 0.3 MPa flow pressure:
• Voltage supply: 100-240 V AC 50-60 Hz/6.75 V DC
• Power consumption:
• Automatic safety shut-off:
(6 - 420 s adjustable)
• Run-on time (0 - 11 s adjustable):
• Reception range according to Kodak Gray Card,
grey side, 8x10", landscape (15 - 35cm adjustable):
Electrical test data
• Software class
• Contamination class
• Rated surge voltage
• Temperature of ball impact test
The test for electromagnetic compatibility (interference emission
test) was performed at the rated voltage and rated current.
Fault / Cause / Remedy
Fault Cause
Water not flowing • Filter in solenoid valve blocked
• Solenoid valve defective
• Plug-in connector without contact
Undesired water • Sensor system detection zone set too high
flow for local conditions
• Automatic flushing activated
• Solenoid valve defective
Flow rate too low • Mousseur dirty
• Filter in solenoid valve dirty
• Filters in connection hose dirty
Mixing device • See "Flow rate too low"
incorrect (36 336) • Limescale on mixer spindle
Functions, programme selection,
see technical product information,
www.grohe.com/tpi/euroeco-ce
D-32457 Porta Westfalica
Installation
Plaster and tile the wall, excluding the area of the
structural shell protection.
Flush pipes thoroughly before and after installation
(observe EN 806)!
Open hot and cold water supply and check that
approx. 9 l/min
connections are watertight.
Temperature adjustment,
2.4 W
60 s
see fold-out page II.
1 s
Maintenance
25cm
•Shut off water supply.
•Disconnect voltage supply.
A •Inspect and clean all components and replace if
2 necessary.
2500 V
Replacement parts
100 °C
see fold-out page I (* = special accessories)
,
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Remedy
- Clean filter
- Replace solenoid valve
- Check plug-in connector
- Reduce range using remote control (special
accessory, prod. no.: 36 407)
- Wait 1 - 10 minutes
- Replace solenoid valve
- Clean or replace mousseur
- Clean filter
- Clean or replace filters
- Clean or replace mixer spindle
GROHE Deutschland
Vertriebs GmbH
Zur Porta 9
, see fold-out page II.
, see fold-out page II.
2