Intended Use - EINHELL BT-PS 1700 Originalbetriebsanleitung

Anleitung_BT_PS_1700_SPK7:_
GB
DC cables in the same empty conduit.
Always fasten electrical cables securely.
Lay electric cables in a manner safely preventing
tripping and cable damage.
Check that the appliance has been delivered in
perfect condition. If it has suffered any damage,
do not connect the appliance to the power supply.
Never cover up the appliance. Air inlets and
outlets must always be clear.
Never attach the 230 V output of the voltage
transformer to another 230 V power source.
When releasing integrated protection devices,
parts of the appliance remain electrically charged.
Always pay attention to the safety information for
the connected 230 V consumer.
Compressor
Do not clean your clothes with compressed air.
Never blow compressed air at people or animals.
Keep the air vents clean.
The compressor should not take in dust or other
impurities.
Do not use the compressor for high pressure
tyres such as lorry tyres, tractor tyres or trailer
tyres.
If you wish to fill several tyres, let the compressor
cool off for 20 minutes between inflations. The
maximum runtime of the appliance must not rise
above 10 minutes.
Important!
The energy station is supplied with a
maintenance-free, leak-proof lead-gel
rechargeable battery. It is delivered partially
charged.
Before first use, the battery for the energy station
must be fully charged!
If the energy station is not used for longer
periods, the battery automatically loses its
charge.
Only use the supplied power supply unit to
recharge the battery.
The warning triangle is not in accordance with the
ECE standard.
Disposal
Batteries: Only dispose of these items through motor
vehicle workshops, special collection points or
special waste collection points.
Ask your local council.
Environmental protection
Please take care that packaging, used batteries or
defective batteries are not disposed of with
household waste. Always dispose of them correctly.
14
22.08.2011 10:53 Uhr Seite 14
2. Layout (Fig. 1 / 2)
1 Jumper cable, black (-)
2 ON/OFF switch jumper cable
3 Battery charge level indicator
4 Pushbutton for battery charge level indicator
5 Flat fuse 15 A
6 Charging socket/LED
7 Light
8 Accessory storage compartment
9 Compressor - pressure indicator
10 Light - ON/OFF switch
11 Compressor - ON/OFF switch
12 Cigarette lighter socket
13 Voltage transformer- ON/OFF switch
14 Socket 230 V
15 Jumper cable, red (+)
16 Warning triangle (integrated)
Accessories (Fig. 3):
20 Spiral air hose
21 Long adapter
22 Short adapter
23 Ball adapter
24 Flat fuse
25 Bicycle valve adapter
26 230 V Charger
27 Motor vehicle adaptor cable

3. Intended use

The appliance is designed for jumpstarting 12 V
starter batteries (lead acid batteries) which have low
battery capacity, as well as for direct or indirect
connection to 12 V consumers with max. 15A power
input at the cigarette lighter socket. Always observe
the operating instructions for the connected
appliance. With the integrated 12 V automatic
compressor, car, motorbike and bicycle tyres, sport
balls, small water balls, small air mattresses or similar
can be inflated.
The voltage transformer serves as a transformer of
the 12 V D.C. from a starter battery into a 230 V / 50
Hz modified A.C. Because of the minimal weight and
the compact build, the appliance can be used in cars,
motor homes etc. The output voltage is equivalent to
the household voltage.
Some switched-mode power supplies work on the
installed voltage transformer only with restrictions or
not at all. Please observe possible notes about
limitations for connection to voltage transformers with
modified sine values in the operating instructions for
the connecting appliance.