Technical Data; Proper Use; Before Putting The Machine Into Operation - EINHELL BT-PG 850 Originalbetriebsanleitung

Anleitung_BT_PG_850_SPK1:_
GB
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1 Tank cover
2 Carry handle
3 Safety tripping element
4 Choke lever
5 ON/OFF switch
6 230 V ~ socket
7 Reversing starter
8 Petrol cock
9 Set of screws for fitting the carry handle
10 Spark plug wrench

3. Proper use

The device is designed for applications operated with
a 230 V alternating current source. Be sure to
observe the restrictions in the safety instructions.
The generator is intended to provide electric tools
and light sources with electricity.
When using the device with household appliances,
please check their suitability in accordance with the
relevant manufacturerʼs instructions. In case of
doubt, ask an authorized dealer of the respective
appliance.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
12
27.09.2010 7:34 Uhr Seite 12

4. TECHNICAL DATA

Generator
Protection type:
Continuous power S1:
Maximum power S2 15 min.:
Rated voltage:
Rated current:
Frequency:
Drive engine design
Displacement
Max. power:
Fuel:
Tank capacity:
Consumption at 3/4 load
Weight:
Sound pressure level L
L sound power level/K uncertainty
WA
Spark plug:
Operating mode S1 (continuous operation)
The machine can be continuously operated with the
quoted power output.
Operating mode S2 (temporary operation)
The machine may be temporarily operated with the
quoted power output. Afterwards the machine must
be stopped for a while to prevent it from overheating.
5. Before putting the machine into
operation
5.1 Electrical safety:
Electric supply cables and connected equipment
must be in perfect condition.
The generator is to be operated only with
equipment whose voltage specifications conform
with the generator's output voltage.
Never connect the generator to the power supply
(socket-outlet).
Keep the cable length to the consumer as short
as possible.
Synchronous
IP 23
650 VA / 650 W
720 VA / 720 W
230 V~
2,8 A~
50 Hz
2-stroke, air-cooled
63 cm 3
0.95 kW / 1.3 PS
Mixture 1:50 (2%)
4.2 l
approx. 0,7 l/h
18.5 kg
: 70 dB(A)
pA
87.62 dB(A) / 3.62 dB(A)
NGK BPR5ES