Bartscher GMS600 Original-Gebrauchsanleitung Seite 51


The device should be filled with product when motor is turned off. Proceed in the
following way:
e) fill the device with selected products for cutting through the hole in the lid (see
fig. 12). Smaller pieces (carrot, zucchini, etc.) insert through the pusher lever
pipe (see fig. 12a). Start the device by pressing Start "I" and gently press the
pusher lever down, while filling through the pipe use plunger.
f) When the pusher lever reaches the end, lift it. The device will be then turned off
by the protection system. The cutting process may be repeated untilobtaining
required amount of product. When the pusher lever is pressed down, the device
turns on again.
g) Replacement of cutting disks should be realized according to section 5.2.3
"Installation and replacement of cutting disks". After that process the
electronic system prevents automatic start: to turn on the device, press Start "I"
h) Containers with cut vegetables should be emptied every 2-3 cutting cycles.
Overfilled containers may hinder normal emptying process, cutting may be
irregular, the device may become jammed, or motor may become damaged.
Fig. 12 Fig. 12a
.
- 47 -