Bartscher GMS600 Original-Gebrauchsanleitung Seite 35


Check the power cord regularly for damage. Do not use the
appliance if the power cord is damaged. If this cable is damaged,
it must be replaced by customer service or a qualified electrician
in order to avoid dangers.

The supply cable must be disconnected from the socket
only by pulling the plug.

Never carry or lift the device by the supply cable.

In any case do not open the device housing. In case of
electrical or mechanical modifications the electric shock
hazard will occur.

Do not use any acid agents and make sure no water ingresses
the device.

Never operate the device with moist hands or standing on wet
floor.

Disconnect the device from the electric power supply.
when the device is not used,
-
in case of anomalies during operation,
-
before cleaning.
-
WARNING! Injury hazard!
To avoid the hazard results please follow the safety instructions
below.

Blades of the cutting disks are very sharp!
Always wear solid, soft protective gloves allowing for firm grip
of objects during installation, replacement, and cleaning of
cutting disks.

Never press the cut products with hand, always use delivered
plunger!
- 31 -