System Settings; Default Settings - Dorr snapshot Extra Gebrauchsanweisung

rEQuEsT LOcaTiOn
With sms #510# the longitude and latitude degrees is reported, based on where the camera is located at the moment of the
shot. the data is based and transmitted via the network operator and are therefore may not be very accurate. a text message
with location of camera will be sent to the mobile phone number which has sent the request.
PicTurE TransMissiOn On/Off
With sms #200#off# the image transmission is turned off. during this time pictures are stored on sd card, but not transmitted
via mms or GPrs. By sending command #200#on# the transmission will be continued. If you sent a wrong sms command, you
will receive a text message showing „command is invalid". during picture transmission or while executing other commands,
you will receive text message showing „command is busy."
saVinG
the entries under „Gsm setuP.exe" can now be saved. the generated file „ProFIle. BIn" can either be saved directly to an
sd card or on the Pc first and then transferred to an sd card. the location is specified in the „Path" window.
Insert the sd card with the „ProFIle. BIn" file into the camera.
DaTa TransMissiOn
switch the camera to „setuP". after a few seconds the message „update success" appears. the parameters are now stored
on the camera.
TEsT shOT
switch camera to „setuP". Wait until camera found network and press
„ok". camera starts manual transmission of picture and work from step 1 to step 10 then display shows „send successfully".
Picture was transmitted to registered phone number or email address.
sys

sysTEM sETTinGs

DaTE & TiME:
TiME sTaMP:
fLash ranGE:
PasswOrD:
LanGuaGE:
sOunD / bEEP:
OVErwriTE funcTiOn:
fOrMaT:

DEfauLT sETTinGs:

When settings are completed, press „menu" to return to starting menu.
PLaybacK
Press in setup mode to watch latest photos. Press ,  to display all pictures. Press "menu" again to return to setup
screen. select video and press
videos can be deleted by pressing "menu" in playback mode and select "delete" and confirm with "ok".
fiLE naME: Pictures and videos will be named continuously, starting with ImG0001.jpg (picture) or ImaG0001.avi (video)
TEsT shOT: In setup mode switch camera
date to be set as dd.mm.yyyy, time to be set in 24h
choose if time & date are shown on pictures or not
select desired setting 6m or 12m
secure camera with password, to avoid misuse. the password is needed every time the camera
is switched "on". default password is "0000". note your password carefully, without the pass-
word the camera cannot be operated.
choose either German or english language
choose "beep" sound on keyboard input or "silent" mode
camera may overwrite old pictures with new ones when sd card is full or alternatively
abandon function
this function deletes all data on the sd card
this sets all parameters to "factory defaults" except date & time
in order to play this video. Press
to manually then take a test shot.
. Press , then press „menu"and confirm with
twice to return to „setuP" menu. single pictures and
21