Bellcome SET VIDEOTÜRSPRECHANLAGE advanced Benutzerhandbuch Seite 32

7.2 Use of the video Terminal
1
The keyboard is not backlit.
At the first touch, the keyboard is backlit and the Terminal may receive the
following commands:
By touching this key, you may see and listen to what goes on at the entrance, in
Stand-by
front of the Outdoor panel. Monitoring is not possible if another Terminal of the
system is being called or is during communication.
// If several video cameras are installed within the system, the successive stroke
of the key changes the camera through which the monitoring is done.
By successive touches of this key, the 3 volume levels are passed through:
maximum (white LED), medium (red-white LED) and turned off (red LED). The red
LED will remain permanently turned on until the key is pressed again.
2
Call duration: maximum 15 s (3 calls)
The LED of the key blinks and the display shows the image sent by the video
camera of the Outdoor panel. By touching the key, communication is initiated.
Call The LED does not blink anymore
Do not touch the key
The second touch of the key ends communication without granting access and
the Terminal returns to stand-by mode.
3
After the command, the lock is unblocked for 1...10 s for the access of the
visitors.
// You cannot grant access without having a prior communication.
Communication
4
No matter what the state of the Terminal is: monitoring, call or
communication, this key may action an automation connected to the
system: auto access or garage gate, lighting system etc.
STAND-BY
AUDIO – VIDEO MONITORING
+VIDEO CAMERA SELECTION
Monitoring duration: 10 s
VOLUME ADJUSTMENT OR
"TERMINAL TURNED OFF"
CALL AND COMMUNICATION
ANSWER THE CALL
Communication duration: maximum 2 min.
during communication.
END COMMUNICATION
NO ACCESS!
ACCESS
ACCESS and
END COMMUNICATION!
COMMAND AUX
AUXILIARY COMMAND
.
15/17