Connection With The Mains; Operation; Addressing - EuroLite RGB TL-150 DMX Bedienungsanleitung

Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the RGB TL-150 DMX starts running.
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing

Each color changer occupies 3 channels. To ensure that the control signals are properly directed to each
color changer, the projector requires adressing. This is to be done for every single color changer by
changing the DIP switches as set out in this table.
The starting address is defined as the first channel from which the RGB TL-150 DMX will respond to the
controller. If you set, for example, the address to channel 4, the RGB TL-150 DMX will use the channel 4 to 6
for control.
International
L
N
21/45
Ω
resistor
41601010_V_1_1.DOC