Special Settings - EuroLite RGB TL-150 DMX Bedienungsanleitung

Please make sure that you don't have any overlapping channels in order to control each RGB TL-150 DMX
correctly and independently from any other fixture on the DMX data link. If two, three or more RGB TL-150
DMX are addressed similarly, they will work similarly.
Occupation of the DIP-switches:
Controlling:
After having addressed all RGB TL-150 DMX, you may now start operating these via your lighting controller.
Note:
After switching on, the RGB TL-150 DMX will automatically detect whether DMX 512 data is received or not.
If the data is received, then the yellow DMX LED blinks.
The DMX-LED is off:
- if there is no data received at the DMX-input.
- if the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the RGB TL-
150 DMX.
- if the controller is switched off or defective.
- if the cable or connector is defective or the signal wires are swap in the input connector.

Special settings

Via the Function-DIP-switches, you can adjust different modes and settings:
22/45 41601010_V_1_1.DOC