Safety Instructions - Klarstein 10033343 Bedienungsanleitung

EN
16

SAFETY INSTRUCTIONS

• Please read the following safety instructions carefully.
• Since the appliance is designed exclusively for outdoor use, it is not permitted to
use the unit indoors.
• Only connect the grill to a properly installed safety socket. This must be operated
via a residual current protective system (RCD) whose tripping current does not
exceed 30 mA.
• The device may only be operated with the mains voltage specified on the type
plate.
• Check the connecting cable and the control box for damage at regular intervals.
If you notice any damage, the device shall not be put into operation under any
circumstances. In this case, please contact costumer service.
• For safety reasons, it is not permitted to apply liquids to the control box (with the
built-in heater and its mains lead) or to immerse it in liquids. The device has the
protection degree "IPX4" and is therefore protected against splashing water.
• Do not under any circumstances operate the appliance with charcoal or other fuels.
• Never cover the grillage or other parts of the grill with aluminium foil, plates, pans
or other objects. Covering the grill surface can lead to heat accumulation, which
can lead to overheating or the destruction of the appliance.
• Never operate the appliance without filling up the water bowl with water. For
further information, please refer to the "Putting into operation" section.
• Children must be kept away from the grill and the connection cable. They are
unable to assess the dangers correctly. Even if you have instructed your children
on the use of the grill and the dangers associated with it, do not leave them
unattended.
• Never allow your children to play unattended near the appliance.
• Packaging material should also be kept away from children, as there is a danger of
suffocation.
• Persons with reduced physical, sensory or mental abilities or lack of experience
are to be supervised in handling the device, unless they have been instructed and
understood in the use and the associated dangers.
• Allow the unit to cool down for at least 30 minutes after usage before cleaning or
disassembly.
• Disconnect the power plug from the socket after each use. This applies in particular
to the cleaning of the device.
• It is not intended to operate the device with an external timer or a separate
telecontrol system.