Safety Instructions For Maintenance - Husqvarna DMS 240 Bedienungsanweisung

To examine the residual-current device
1. Connect the product to the mains socket. Push the
RESET button and the red LED comes on.
2. Start the product.
3. Push the TEST button.
4. The ground fault circuit interrupter should trip and
the product should stop immediately. Get support
from your dealer if the product does not stop.
5. Reset with the RESET button.
Safety instructions for diamond tools
• When performing drilling that requires the use of
water, route the water away from the operator's work
area or use a liquid collection device. Such
precautionary measures keep the operator's work
area dry and reduce the risk of electrical shock.
10
• Operate power tool by insulated grasping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
• Wear hearing protection when diamond drilling.
Exposure to noise can cause hearing loss.
• When the bit is jammed, stop applying downward
pressure and turn off the tool. Investigate and take
corrective actions to eliminate the cause of the bit
jamming.
• When restarting a diamond drill in the workpiece
check that the bit rotates freely before starting. If the
bit is jammed, it may not start, may overload the tool,
or may cause the diamond drill to release from the
workpiece.
• When securing the drill stand with anchors and
fasteners to the workpiece, ensure that the
anchoring used is capable of holding and restraining
the machine during use. If the workpiece is weak or
porous, the anchor may pull out causing the drill
stand to release from the workpiece.
• When drilling through walls or ceilings, ensure to
protect persons and the work area on the other side.
The bit may extend through the hole or the core may
fall out on the other side.
• Do not use this tool for overhead drilling with water
supply. Water entering the power tool will increase
the risk of electric shock.
• When drilling overhead, always use the liquid
collection device specified in the instructions. Do not
allow water to flow into the tool. Water entering the
power tool will increase the risk of electric shock.

Safety instructions for maintenance

WARNING: Inspection and/or maintenance
should be carried out with the motor
switched off and the plug disconnected.
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
898 - 002 - 20.06.2019