Operation - Husqvarna DMS 240 Bedienungsanweisung

To attach the drill stand with an expander bolt
1. Make a hole for the expander bolt. Measure a
distance of 335 mm (13.2 in.) from the center of the
hole that you will drill.
335 mm
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Keep the work area clean and bright to prevent
accidents to occur.
3. Do a daily start and stop check. Refer to
check of the ON/OFF switch on page 9
4. Do daily maintenance. Refer to
the drill motor on page 14 .
5. Make sure that the product is installed correctly. The
drill bit and drill stand must be attached correctly.
Use an applicable method to attach the product on
the drill stand.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
7. Make sure that the water system is not damaged
and is connected to the product.
8. Make sure that the residual-current device is started.
Residual-current device on page 9 and To
Refer to
examine the residual-current device on page 10
12
(13,2")
To do a
Daily maintenance of
2. Attach the bottom plate with an expander bolt.
3. Tighten the expander bolt fully.
4. If it is necessary, adjust the bottom plate. Use the
level adjustment screws to adjust the bottom plate to
the surface.
To attach the drill stand with a rod that has a
thread
1. Examine the surface quality of the roof or walls to
see if the surface quality is sufficient to make holes
in.
2. If the surface quality is sufficient, attach the bottom
plate with a rod that has a thread.
3. Install the drill stand with a washer and locknut.

Operation

898 - 002 - 20.06.2019