Sabiana LC-15-W Handbuch Für Installation, Gebrauch Und Wartung Seite 45

LC-W / LC-E
- MASTER-SLAVE
Managinga group of appliances, via serial connec-
tion, with the infra-red control.
It is possible to connect multiple devices controlling
them simultaneously, transmitting settings from the
control to a single MASTER unit.
The operation of each individual appliance will depend, on
the other hand, on the temperature conditions measured
by each of these.
Note!: The Master unit will have Dip 4 positioned
on OFF, while all other devices connected as Slave
will have Dip 4 positioned ON.
°C
AUTO
T-MB
Explain about installing and grounding of one RS 485
networks
tor copper cable.
Installation remarks
- When pulling cable, use less than 12 kg of force.
More force may stretch the cable and distort its insula-
tion and transmission properties.
- Don't allow the cable to kink, knot, snag, or fray when
rolling it out or securing it.
- Don't run communications cable in the same conduit
as electrical cable.
- If you cross electrical cable, cross at a 90° angle.
- Don't splice cable segments. Use continuous runs of
cable from one device to another or from one termina-
tion block to another.
- Don't cinch cables ties too tightly. Tie-wrap cable
bundles loosely. Don't crush cables when securing
them with staples or supports. Staple by hand or use
staples with depth stops.
DIP 4 OFF
Master
+
SELV BOARD
M Fan
1 2 3 4 5 6
- Maintain the colour coding of all cabling throughout
your system.
- Visually and physically inspect terminations to verify
that they're sound.
- Never place communications cable in any conduit,
or lighting circuits of any type.
- Keep communications cable and controllers at least
2 meters from large inductive loads (power distribution
panels, lighting ballasts, motors, etc.).
TX-RX GND TX-RX GND
ON
-
English
DIP 4 ON
Slave
TX-RX GND TX-RX GND
SELV
BOARD
ON
5 6
45