Operating And Safety Instructions; Warranty And Disclaimer - BWT AQA drink 1 CAS Installations- Und Bedienungsanleitung

4. Operating and safety instructions

These installation and
contain important information concerning the safe
and efficient use of the AQA drink 1 water dispenser.
Despite all safety precautions, there remain residual
hazards with every product, especially if it is not
handled properly. Every technical device requires
regular maintenance and servicing (Chapter 6)
to work properly. Compliance with all safety and
handling instructions provided is a fundamental
requirement for safe operation. In addition, the
local accident prevention regulations and general
safety regulations valid at the location of the device
apply.
Danger due to electricity!
Before performing maintenance work on this device,
it must be disconnected from the mains supply.
It must be possible to disconnect the electric current
either by pulling out the power cable or by means of
a biploar mains switch at the socket.
If the power cable is damaged, it must be replaced by
the manufacturer or a qualified technician.
Do not use extension cables or multiple adapters.
Check to ensure that the voltage indicated on the
type plate matches that in the installation location.
The device must be secured with an earthing switch.
Earthing the device is a legal requirement.
The electrical connections must comply with local
standards.
This water dispenser was designed and constructed
in accordance with the Low Voltage Directive
2006/95/EC and the protection regulations of the
EC directive 2004/108 EMC.
Caution!
In the event of any use other than for the intended
purpose, e.g. the use of the water dispenser for the
treatment of water which is not of drinking water
quality, drinking this water may constitute a danger
to health:
- microbiological risk as a result of exposure to
pathogenic germs
- risk due to high concentrations of heavy metals or
organic contaminants
20
operation instructions
Caution!
Before maintenance work is carried out on the drink-
ing water supply, disconnect the device from the
water supply. Rinse the water pipe before the device
is reconnected.
Comply with all
regulations (e.g. DIN 1988, EN 1717), general hygiene
conditions and technical data relating to the
protection of drinking water.
The materials of the water dispenser which are
in direct contact with the water comply with
the regulations and and common food insdustry
standards. The device was manufactured according
to the provisions of the Italian Ministerial Decree D.M.
174 of 06/04/2004 and D.M. 25 of 07/02/2012.
Avoid storing the device for unnecessarily long
periods in order to minimise the risk of microbial
contamination.
The lines of the coolant circuit must not be damaged
because they are filled with R134a gas, which is
highly inflammable. Check the lines on a regular
basis.
Set up the unit in a clean, dry and well-ventilated
room. The AQA drink 1 water dispenser is designed
for room temperatures of between 5 °C and 32 °C –
climate class N.
Do not set up the unit near sources of heat or open
flames.
Chemicals, solvents and vapours must not come into
contact with the device.
The installation location must be protected from frost
and direct sunlight.

4.1 Warranty and Disclaimer

The AQA drink 1 water dispenser has a 2-year war-
ranty. The specified information and recommenda-
tions, as well as the local drinking water and waste
disposal regulations valid for the application in
question, must be complied with. All information
and instructions in these installation and operating
instructions take account of applicable standards
and regulations, the state of the art, as well as our
many years of knowledge and experience. Illustra-
tions in this manual are intended to provide a basic
understanding and may vary from the actual design
of the device. No claims may be derived from this.
BWT can accept no liability for damage or conse-
quential damage due to:
» non-compliance with the information given in
these installation and operating instructions;
» use for purposes other than the intended
purpose;
country-specific installation