Maintenance - EINHELL TS 230 Bedienungsanleitung

Anleitung TS 230_SPK1:_
GB
connection, please read the instructions and
particularly the safety information. Only use a
fully mounted machine.
29.Use the accessory parts and electric tools for
their intended purpose only.
30.Check to see if the accessory parts are not
damaged. Also make sure the moving parts of
the clamping device and safety guard are working
correctly.
31.Be alert at all times. Concentrate on what you are
doing. Use common sense. Never use the
electric tool when you are distracted.
32.The cutting stand is designed for cutting ferrous
metals. Do not try to cut wood, brick or other
unsuitable materials.
33.Do not stand in the cutting direction after a new
cutting-off wheel has been fitted. Allow the
machine to run for approximately one minute
before you begin with the cutting. If the cutting-off
wheel has an invisible fracture or defect, it will
burst in less than one minute.
34.Keep your electric tools in a safe place. When
equipment is not being used it should be kept in a
dry, closed place out of children's reach.
35.Wear suitable work clothes. Do not wear loose
clothing or jewelry as they may get caught in
moving parts. Non-slip shoes are recommended.
Wear a hair net if you have long hair.
36.Always remove keys and wrenches after use.
Before switching on, make sure that all keys and
wrenches have been removed from the tool.
3. Proper use
The cutting stand is designed for the cutting of metal
using an angle grinder (with a cutting wheel diameter
of 230 mm).Please note that our equipment has not
been designed for use in commercial, trade or
industrial applications. Our warranty will be voided if
the machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Assembly
See Fig. 2 to 13
5. Starting up
After you have switched on, lower the cutting-off
wheel slowly until it comes into contact with the
workpiece. Then carry out a smooth cut. Avoid
causing the cutting-off wheel to jump or chatter. This
will only lead to premature wear and result in poor
10
22.12.2006 6:53 Uhr Seite 10
cuts or a broken cutting-off wheel.
6. Technical data
Applies for 230 mm angle grinder
Weight: 3,4 kg

7. Maintenance

Always keep the cutting stand clean.
Never use caustic agents to clean plastic parts.
8. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.