Personnel Qualification; General Safety Precautions - HEIDENHAIN ND 2100G GAGE-CHEK Installationsanleitung

Installation Instructions en
2 Safety
General accepted safety precautions, in particular the
applicable precautions relating to the handling of live
electrical equipment, must be followed when operating the
system. Failure to observe these safety precautions may
result in personal injury or damage to the equipment.
It is understood that safety rules within individual
companies vary. If a conflict exists between the material
contained in these instructions and the rules of a
company using this system, the more stringent rules take
precedence.
2.1

Personnel qualification

The personnel for mounting and installation must be
appropriately qualified for this work and must have obtained
sufficient information from the documentation supplied with
the product and with the connected peripherals.
The personnel required for the individual activities to be
performed on the product are indicated in the respective
sections of these instructions.
The personnel groups that are responsible for mounting and
installation have different qualifications and tasks, which are
specified as follows.
Qualified personnel
The qualified personnel are trained by the operating
company to perform advanced operation and
parameterization. The qualified personnel have the required
technical training, knowledge and experience and know the
applicable regulations, and are thus capable of performing
the assigned work regarding the application concerned and
of proactively identifying and avoiding potential risks.
Electrical specialist
The electrical specialist has the required technical training,
knowledge and experience and knows the applicable
standards and regulations, and is thus capable of performing
work on electrical systems and of proactively identifying
and avoiding potential risks. Electrical specialists have been
specially trained for the environment they work in.
Electrical specialists must comply with the provisions of the
applicable legal regulations on accident prevention.
14
2.2 Obligations of the operating company
The operating company owns or leases the product and
the peripherals. It is responsible that the intended use is
complied with at all times.
The operating company must:
Assign the different tasks to be performed on the
product to appropriate, qualified and authorized
personnel
Train the personnel in the authorizations and tasks
specified in "Personnel qualification", page 14
Ensure that the product is operated only when in perfect
technical condition
Ensure that the product is protected from unauthorized
use
2.3

General safety precautions

The product supports the use of a wide variety of
peripheral devices from different manufacturers.
HEIDENHAIN cannot make any statements
on the specific safety precautions to be taken
for these devices. The safety precautions
provided in the respective documentations
must be observed. If no such information has
been supplied, it must be obtained from the
manufacturers concerned.
The specific safety precautions required for the individual
activities to be performed on the product are indicated in
the respective sections of these instructions.
ND 2100G GAGE-CHEK