Klarstein Glacial Handbuch Seite 27

Fault Inspection
The compressor is Power supply
unable to start or
stops abruptly.
Air inlet
Condenser
Refrigerating
system
Compressor
The water keeps Inlet valve
flowing into the
water tank.
Water level sensor
Leakage Water inlet
Inlet pipe or drain
pipe
Ice making time is Water supply
too long pressure
Water
temperature
Ambient
temperature
Refrigerant
Inlet valve
Cause Solution
Voltage is too low Contact your
electricity supplier.
The air inlet is Keep a distance
blocked. of at least 15 cm
to the left and
right sides and the
rear.
Too much dust Clean the
condenser.
Refrigerating Contact
system leakage constumer service.
The connection Contact
cable is broken or constumer service.
defective.
The inlet valve Replace the inlet
has an internal valve.
leakage.
Water level Contact
detection is not constumer service.
sensitive.
Loose or not in Tighten or reinstall
place
There is a rupture Replace
that causes a leak.
Water pressure Increase the water
is too low, water pressure.
supply time is too
long every time.
Water Reduce the water
temperature is too temperature.
high.
Ambient Place the machine
temperature is too in a room with
high or too low. an appropriate
temperature.
Refrigerant Contact
leakage. constumer service.
Leakage leads Replace the inlet
to a long cooling valve.
time.
EN
27