Hilti WSR 900-PE Original Bedienungsanleitung Seite 24

5.7 Switching the orbital-action function on and off
The orbital-action function can increase cutting performance in certain materials such as wood-based
products, for example.
Allow the product to come to a complete stop before you engage or disengage the orbital-action
function.
▶ Switch the orbital-action function on or off by setting the orbital-action switch to the appropriate limit
position.
5.8 Inserting the pipe-cutting adapter
1. Disconnect the supply cord plug from the power outlet.
2. Remove the saw blade. → page 17
3. Remove the contact shoe by pressing and holding down the lock and working the contact shoe forward
until it disengages.
4. Push the pipe-cutting adapter into the guide and install the saw blade.
5. Grip and pull the pipe-cutting adapter to check that it is locked in position.
6. Release the screw clamp on the pipe-cutting adapter fully.
7. Loop the chain around the pipe and hook the chain back onto the pipe-cutting adapter.
The clamping screw should be at an angle of 45° to the saw.
5.9 Adjusting the stroke rate
Please refer to the application table for the recommended stroke rate settings.
1. Set the stroke rate to a setting between 1 (low) and 6 (high) by turning the stroke rate regulator.
2. Press the control switch.
➥ The power tool will then run at the preselected stroke rate.
5.9.1 Stroke rate setting
Material to be cut
Wood
Wood containing nails
Interior finishing, drywall
Plastic
Steel
Non-ferrous metals
Aluminum
Stainless steel
5.10 Plunge cutting 5
WARNING
Risk of injury! Risk of kickback.
▶ Apply the appropriate safety measures at the rear of the workpiece when plunge sawing. Use only
suitable saw blades (length as short as possible).
Use the plunge cutting technique only on soft materials and with short saw blades. The product can
be used in one of two plunge cutting positions: in the normal position or in the reversed position.
1. Bring the forward edge of the AVR contact shoe into contact with the workpiece.
18 English
Printed: 23.07.2019 | Doc-Nr: PUB / 5138031 / 000 / 03
3
6
3
Suggested stroke rate settings
5-6
5-6
3-4
3-4
2-3
2-3
2-3
1
378282
*378282*