Technical Data - LaserLiner PowerPlane-Laser 3D Bedienungsanleitung

Checking the vertical line:
Position the device about 5 m from a wall. Fix a plumb bob with a line of
2.5 m length on the wall, making sure that the bob can swing freely. Switch
on the device and align the vertical laser to the plumb line. The precision is
within the specified tolerance if the deviation between the laser line and the
plumb line is not greater than ± 1 mm.
Checking the horizontal line:
Position the device about 5 m from a wall
and switch on the cross laser. Mark point B
on the wall. Turn the laser cross approx. 2.5 m
to the right and mark point C. Check whether
the horizontal line from point C is level with point B to within ± 1 mm.
Repeat the process by turning the laser to the left.
!
Regularly check the calibration before use, after transport and after
extended periods of storage.

Technical data

Self-levelling range
Accuracy
Operating range (depending on room illumination)
Working range with hand receiver (depends on how
the technology affects the difference in brightness)
Laser wavelength
Laser class
Power supply
Operating time
with 3 laser levels
with 2 laser levels
with 1 laser level
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries and alignment edge)
14
EN
B
Subject to technical changes without notice. 01.2017
± 2.5°
± 0.2 mm / m
20 m
50 m
635 nm
2 / < 1 mW
4 x 1.5 V alkaline
batteries (type AA, LR6)
approx. 4 hours
approx. 10 hours
approx. 25 hours
0°C ... +50°C
-10°C ... +70°C
85 x 130 x 155 mm
875 g
2,5 m
C