Preparing Other Drinks; Making Drinks With Hot Water; Making Drinks With The Super Cappuccino Accessory Or The Steam Nozzle; Super Cappuccino Accessory (Depending On Model) - Krups Espresso Automatic EA83 series Handbuch

For drinks with frothy milk or hot water, the drip tray has been specially designed to allow you to fit a large
cup under the steam nozzle or the super cappuccino accessory, once the magnetised box has been
removed. The cup is ideally positioned to collect the frothy milk or the hot water produced by the nozzle
or the super cappuccino accessory. Furthermore, you can use the box as storage for the super cappuccino
accessory.

5.1 Making drinks with hot water

Make sure that the steam nozzle is securely fitted on its tip.
While the screen displays the drink selection menu, press the "hot water" key
A message will invite you to place a container under the steam nozzle. Again press the "hot water"
to produce hot water.
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
6. MAKING DRINKS WITH THE SUPER CAPPUCCINO
ACCESSORY OR THE STEAM NOZZLE (depending on model)
Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up
liquids. As you need a higher temperature to produce steam than to make an espresso, the
appliance runs an additional pre-heating phase for steam.
While the screen displays the drink selection menu, press the "steam" key
A screen will inform you that the appliance is being pre-heated. Once the pre-heating phase has been
completed, a message will ask you to place a container under the steam nozzle. Press the "steam" key
again to start generating steam. A little water will be produced first and then steam will start. Use the same
key to stop steam generation.
Be careful, because the cycle does not stop immediately.
!
Note: We recommend that you use very cold, fresh pasteurised or UHT milk that has been recently
opened. Do not use untreated milk.

6.1 Super Cappuccino Accessory (depending on model)

The super cappuccino accessory helps the preparation of a cappuccino or latte.
Attach the various parts together. Fig. 16
Put the beveled end to the milk.
Select the cappuccino or caffe latte position on the special nozzle. Fig. 17
Fill up the milk pot and place a cup or a glass underneath the Super-cappuccino nozzle.Fig. 18-19
Press the button to start and then to stop the cycle.
Place your cup under the coffee outlets and start a coffee / espresso cycle. Fig. 20
!
Important: The inlet must not be twisted.
Cleaning and maintenance: remove the accessory and clean the parts using a small brush and, if necessary,
a little washing-up liquid. Make sure to carefully clean the parts circled in the photo. The hole in the metal
part should not be allowed to become blocked. Fig. 21.
To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly after use..
It is recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot
filled with water in order to clean the inside of the nozzle. To do so, you can also use liquid cleaner, available
as an accessory.
28

5. PREPARING OTHER DRINKS

. Fig. 14.
. Fig. 15.
key