Krups Espresso Automatic EA83 series Handbuch Seite 32

MALFUNCTION
No steam is coming out of
the steam spout.
The super cappuccino ac-
cessory does not make any
or makes little foam.
The super cappuccino ac-
cessory does not suck up
the milk.
The machine is asking you
to empty the drip tray even
though it is not full.
There is water under the ap-
pliance.
When you turn off the ap-
pliance, warm water comes
out of the coffee nozzles.
After emptying the coffee
grounds collector and clea-
ning the coffee drawer, the
warning message is still dis-
played.
The coffee comes out too
slowly.
Water or steam are
abnormally coming out of
the steam spout.
After filling the water tank,
the warning message
remains on the screen.
34
CORRECTIVE MEASURES
Empty the tank and temporarily remove the Claris cartridge.
Fill the tank with calcium rich mineral water (>100 mg/l) and per-
form successive steam cycles (5 to 10) into a container until you
obtain a constant flow of steam.
Re-insert the Claris cartridge into the tank.
Check that the accessory is correctly fitted to the appliance, re-
move it and then replace it.
Check that the flexible hose is not obstructed or pierced shaped
and that it is correctly connected to the accessory to avoid any
air entering.
Rinse and clean the accessory (refer to the "Super cappuccino
accessory" chapter).
If the problem persists replace the part surrounded in red on Fig.
21 with the replacement part supplied with your machine.
The machine is programmed to ask for drainage of the drip tray
every 12 coffees, irrespective of any intermediate drainage that
you may carry out.
Before lifting off the tank, wait for 15 seconds after the coffee has run
through so that the machine finishes its cycle correctly.
Check that the drip tray is correctly positioned on the machine, it must
always be in place, even when your appliance is not being used.
Check that the drip tray is not full.
The drip tray must not be removed during a cycle.
According to the type of recipe prepared, the machine can carry
out an automatic rinsing operation when it is turned off. This cycle
lasts only a few seconds and stops automatically.
Correctly refit the coffee drawer and the coffee grounds collector,
follow the instructions on the screen.
Wait at least for 8 seconds before refitting them.
Turn the grinding setting button to the right for coarser coffee
grounds (this can depend on the type of coffee used).
Perform one or several rinse cycles. Launch a clean programme
(see" Machine cleaning programme" p.30).
Change the Claris Aqua Filter cartridge (see "Filter installation"
p.25).
At the start or end of the recipe some drops may fall from the
steam nozzle.
Check that the tank is correctly positioned in the appliance.
Check and unblock the float if necessary. The float at the bottom
of the tank should move freely.