Technical Data - Electrolux WASL5T300 Benutzerinformation

30 www.electrolux.com
Problem
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The washing results are
not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.

14. TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
Water supply pressure Minimum
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
• The ProSense function is able to adjust the programme
duration according to the type and the laundry load size.
Refer to "The ProSense load detection" in "Daily Use"
chapter.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains be‐
fore you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.
• Make sure that the flap is in the correct position (left for
powder detergent - right for liquid detergent).
• Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.
Width/ Height/ Depth/
Total depth
Voltage
Overall power
Fuse
Frequency
Maximum
1)
Cotton
Maximum spin speed
400 mm/ 890 mm/ 600 mm/ 600
mm
230 V
2200 W
10 A
50 Hz
IPX4
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
6 kg
A+++
1451 rpm