Intended Use; Installation; Establishing The Connections - Oase AquaMax Eco Premium 6000 12V Gebrauchsanleitung

- EN -

Intended use

AquaMax Eco Premium 6000 12 V, 12000 12 V, referred to as "unit", may only be used as specified in the following:
• For pumping normal pond water for filters, waterfalls and water courses.
• Operate in accordance with instructions.
• Operation under observance of the permissible water quality. (→ Water quality)
The unit is suitable for use in swimming ponds (A) if the national regulations valid for installers are met.
The following restrictions apply to the unit:
• Never use the unit to convey fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Do not connect to the domestic water supply.

Installation

The unit can be placed submerged or dry.
Always place the unit below water level.
Place the unit horizontally on the ground ensuring its stable position.

Establishing the connections

 B
Recommendation for the use of the stepped hose adapter and hose connector:
AquaMax Eco Premium 6000 12 V:
• Second inlet (1): Stepped hose adapter 1 to 1½ "
• Pump outlet (2): Hose connector 1½ " (alternative: stepped hose adapter 1 to 1½ ")
AquaMax Eco Premium 12000 12 V:
• Second inlet (1): Stepped hose adapter 1 to 1½ "
• Pump outlet (2): Hose connector 2 " (alternative: stepped hose adapter 1 to 1½ ")
Push the hose clip and the union nut over the hose. Fit the hose on the stepped hose adapter or hose connector and
secure with the hose clip.
Fit the stepped hose adapter or hose connector on the second inlet (1) or pump outlet (2) and hand-tighten the union
nut.
Operate the unit with the pond filter.
 B
• Close the inlet (suction side) with the cover cap.
• Connect the outlet (pressure side) to the pond filter.
Operate the unit with the satellite filter, or with the skimmer and pond filter.
 C, D
• Connect the inlet (suction side) with the satellite filter or skimmer.
• Outlet (pressure side) with pond filter.
Set the inlet regulator
 F
• Unlock the locking (pull towards the inlet regulator) while pushing the inlet regulator to the desired position:
– Position 0: Second inlet closed. Water is only drawn in via the housing (strainer casings).
– Position 1 to 3: Part of the water is drawn in via the housing (strainer casings), and part via the second inlet.
– Position 4: Second inlet opened to the max. position. Water is only drawn in via the second inlet.
12