clage Zip HydroTap G4 B 160 Gebrauchsanleitung Seite 33

LCD Screen operation - Section F
Note:
Any attempt, during OFF mode, to dispense water, will bring
the unit out of energy mode. The system will revert to the energy
mode setting after 30 minutes of non use.
Safety
Change the savety settings
1. Press the [MENU] button for
main menu.
2. Press the [Setting] button.
3. Press the [Safety] button.
Hot Isolation
The HydroTap is equipped with a safety mode that allows for addi-
tional safety protection, if needed.
To Activate the Hot Isolation
1. Press button C to enable hot isolation.
2. Then tap the safety lock three times rapidly, the LED's will scroll
from right to left three times and the hot isolation will be active.
3. To de-activate, press button C to disable hot isolation.
To operate the tap when in Hot Isolation mode, tap the Safety Lock
three times rapidly, the LED's will scroll from right to left three
times. This operation confi rms de-activation and will remain de-ac-
tivated for 30 seconds. The Hot Isolation can be immediately set
again, by tapping the safety lock three times rapidly.
A
Group set
1. Press group set option 1 / 2
2. Press button A to enable /
disable group set. When the
enable box is ticked, this allows
each individual day to have an
"On/Off "time.
3. Then press the [ON/OFF
Modes] button, to set up ON/
OFF time.
33
A
B
C