Specifications - Monacor SAM-500D Bedienungsanleitung

a way that it will optimally complement the
frequency response of the other speakers .
4) When the speakers are placed at different
distances to the listener, phase cancellation
may result (certain frequencies are repro-
duced at a lower volume) . To compensate
this effect, shift the phase of the subwoofer
signal with the control PHASE (4) .
Test the positions of the control to find
the one offering the bass reproduction of
the highest volume at the listening position .
Then readjust the volume balance with the
LEVEL control (2), if required .
5) If there is no signal at the input for more than
approx . 25 minutes, the amplifier module
goes on standby: The LED STANDBY / POWER
(1) shows red . If the amplifier module is not in
use for longer intervals, switch off the ampli-
fier module with the POWER switch .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®

6 Specifications

Amplifier power at 4 Ω / 8 Ω
RMS power: . . . . . . . 500 W/ 250 W
Peak power: . . . . . . . 700 W/ 350 W
Frequency range
(upper cut-off frequency
is variable): . . . . . . . . . . 20 – 40 ... 200 Hz
Load impedance: . . . . . 4 – 8 Ω
Input impedance
LINE IN: . . . . . . . . . . . 22 kΩ
HIGH LEVEL INPUT: . . 270 Ω
Input sensitivity
LINE IN: . . . . . . . . . . . 170 mV
HIGH LEVEL INPUT: . . 1 V
Input voltage max .
LINE IN: . . . . . . . . . . . 7 V
HIGH LEVEL INPUT: . . 20 V
THD: . . . . . . . . . . . . . . . < 1 %
S / N ratio: . . . . . . . . . . . > 70 dB
Power supply: . . . . . . . . 230 V/ 50 Hz
Power consumption
Full load: . . . . . . . . . . 840 VA
No-load: . . . . . . . . . . 38 VA
Standby: . . . . . . . . . . 0 .5 W
Ambient temperature: . 0 – 40 °C
Dimensions: . . . . . . . . . 251 × 270 × 90 mm
Weight: . . . . . . . . . . . . 2 .5 kg
Subject to technical modification .
11