Operating Elements And Connections - Monacor SAM-500D Bedienungsanleitung

Amplifier Insertion Module
for Subwoofers
These instructions are intended for non-pro-
fessionals with basic knowledge in DIY speaker
building . Please read the instructions carefully
prior to operation and keep them for later
reference .
1 Operating Elements
and Connections
1 Status LED
red = standby
green = power amplifier switched on
2 LEVEL control
3 CUT OFF control to set the cut-off frequency
for the subwoofer
4 PHASE control to shift the phase of the out-
put signal compared to the input signal
5 Input LINE IN (RCA jacks) for signals with line
level; when both jacks are connected (e . g .
stereo signal), the signals internally create a
sum signal (mono)
8
1 2 3 4
STANDBY
POWER
LEVEL CUT OFF PHASE
MIN MAX 40 Hz 200 Hz 0° -180°
SAM-500D
6 Output LINE OUT (RCA jacks) to route the
7 Screw terminals HIGH LEVEL INPUT as a sig-
8 POWER switch
9 Mains jack for connection to a socket
10 Support for the mains fuse
5 6 7
LINE IN LINE OUT HIGH LEVEL INPUT
R R
L / LFE
L
SAM-500D
DIGITAL SUBWOOFER MODULE
MONACOR INTERNATIONAL ZUM FALSCH 36 28307 BREMEN GERMANY
• • •
T4AL
230V~ / 50Hz / 840VA
AUTO 230V~/
ON
OFF
USE ONLY WITH A 250V FUSE
POWER
input signal e . g . to another amplifier
nal input to connect the speaker outputs of
a power amplifier [instead of using the RCA
jacks LINE IN (5)]
(230 V/ 50 Hz) via the mains cable provided
Always replace a blown fuse by one of the
same type .
8
9
50Hz
10
FUSE