Hilti TE 700-AVR Original Bedienungsanleitung Seite 22

Observe the safety instructions and warnings in this documentation and on the product.
5.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Slide the side handle clamping band over the chuck from the front and into the recess provided.
2. Bring the side handle into the desired position.
3. Secure the side handle by turning the knob until the clamping band is tight.
5.3 Fitting the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also have sharp edges.
▶ Wear protective gloves when changing the tool.
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
Note
Check the accessory tool for damage or uneven wear each time before use and replace it if necessary.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage to
the product.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
◁ The product is ready for use.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.
5.4 Removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Pull the chuck back.
2. Remove the accessory tool.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.
16 English
Printed: 02.02.2017 | Doc-Nr: PUB / 5071173 / 000 / 04
2
3
4