Braun Typ 4644 Gebrauchsanweisung Seite 10

cover of the opening (6). Insert the
handblender attachment (9) into the
opening so that the marking on the
handblender attachment aligns with the
marking on the motor part. Then turn
the handblender 90° clockwise, until it
locks.
• Insert the handblender attachment
vertically into the vessel, before switch-
ing on the appliance. The handblender
may not be immersed more than 2/3
of the shaft.
• Press and hold the on/off switch as
long as you operate your handblender
attachment.
• Should you want to blend directly in the
saucepan while cooking, take the pan
from the stove first and allow cooling
down to protect your handblender
attachment from overheating. Never
use the handblender attachment in very
hot or boiling ingredients.
• To turn off the appliance, release the
on/off switch, before taking the shaft
out of the vessel, then unplug.
• To remove the handblender attach-
ment, turn it 90° anti-clockwise and
pull it off.
Important: The beaker (10) may be used
only with the handblender attachment for
processing smaller quantities. It should
not be used with a whisk.
Using the chopper
attachment (C)
The chopper attachment is perfectly
suited for chopping meat, cheese,
onions, herbs, garlic, carrots, walnuts,
hazelnuts, almonds etc.
• Before chopping: Pre-cut meat,
cheese, onions, garlic, carrots (see
table on page 5), remove stalks from
herbs, un-shell nuts and remove bones,
tendons and gristle from meat.
• Always make sure that the anti-slip ring
(11d) is attached to the bowl.
• Caution: Carefully remove the plastic
cover from the blade (11b). The blade
is very sharp! Always hold it by the
upper plastic part.
• Place the blade insert on the centre pin
of the chopper bowl and press it down
until it locks.
• Fill the food into the chopper bowl.
• Put the chopper lid (11a) on the chop-
per bowl and make sure it is properly
fitted.
10
5722210014_M1000_S06_S68.indd 10 5722210014_M1000_S06_S68.indd 10
• To attach the motor part, slide up the
cover of the opening (6) and insert the
pin of the chopper lid into it, so that the
marking on the chopper lid aligns with
the marking on the motor part. Then
turn the motor part 90° clockwise, until
it locks.
• Keep the on/off switch pressed down
as long as you operate your chopper
attachment and always hold the motor
part with your hand. For chopping hard
goods (e.g. hard cheese), use the turbo
speed setting.
• When chopping cooked food, allow it
to cool down for a few minutes before
putting it into the chopper bowl.
• Turn the appliance off by releasing the
switch and unplug it, before you start
disassembling.
• To remove the motor part, hold the
chopper attachment with one hand,
turn the motor part 90° anti-clockwise
and lift it off.
• Remove the blade insert, before you
remove the processed food from the
chopper bowl.
Important: Do not chop extremely hard
food, such as ice cubes, nutmeg, coffee
beans or grains.
Recipe example:
Dried Fruit in Vanilla-Honey
(as a pancake stuffing or spread)
(Use the chopper attachment (11),
speed: turbo)
Fill 300 g creamy honey, 150 g prunes
and 150 g dried figs into the chopper
bowl and chop 10 seconds, then add
100 ml water and 3 drops vanilla aroma
and resume chopping for 3 seconds.
Cleaning the appliance (D)
Always unplug the appliance before
cleaning.
The motor part and the chopper lid
should be cleaned with a damp cloth
only. Do not immerse these parts in water
or hold them under running water.
N.B.: When processing foods with colour
(e.g. carrots), the plastic parts of the
appliance can become discoloured.
Wipe these parts with vegetable oil,
before placing them in the dishwasher.
The dough hooks, whisks, the beaker,
the chopper bowl and the blade can be
cleaned in the dishwasher.
05.06.13 15:45 05.06.13 15:45