Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Getting Started - Klarstein Stella Prima Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

INSTALLATION

• Take out all the packing. If there is a safe film over the oven, tear it off before
Use. Check carefully for damage. If any, immediately notify dealer or send to the
manufacturer's service center.
• Microwave ovens must be placed under dry and non corrosiveness environments,
kept away from heat and humidity, such as gas burner or water tank.
• To ensure sufficient ventilation, the distance of the back of microwave to the wall
should be at least 10 cm, the side to the wall should be at least 5 cm, the free
distance above the top surface at least 20 cm. the distance of the microwave to the
ground should be at least 85 cm.
• The position of the oven shall be such that it is far from the TV, Radio or antenna as
picture disturbance .The distance should be more than 5m.
• The appliance must be positioned so that the plug is accessible.
• The microwave oven must be operated with the door closed.
• The microwave must not be placed in a cabinet. The microwave oven is intended to be
used freestanding.
• The back of the oven must be placed against a wall
• As there is manufacturing residue or oil remained on the oven cavity or heat
element, it usually would smell the odor, even a slight smoke, It is normal case and
would not occur after several times use, keep the door or window open to ensure
good ventilation. So it is strongly recommended to set the oven to grill mode and
operate dry several times.

GETTING STARTED

The LED flashes 3 times when plugged in power supply. Then it flashes ":", prompting
you to input the cooking menu and time.
Auto reminder
When your preset cooking procedure has finished, the LED Display will show End and
three beeps sound will be heard to prompt you to take out food. If you do not press
Pause/Cancel button once or open the door, the beep will sound at an interval of 3
minutes.
Clock setting
Clock button make it available for you to input current or preset time when ":" flashes
onto LED display after plugged in, or try to skip it over to continue if unnecessary.
EN
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis