Installation - Klarstein 10032639 Bedienungsanleitung

INSTALLATION

Important information about installation
• This appliance is NOT intended for use in a commercial environment.
• Please observe the installation instructions provided and note that this appliance
should only be installed by a quali fied technician.
• Please observe the installation instructions provided and note that this appliance
should only be installed by a quali fied technician.
• The appliance is fitted with a plug and must only be connected to a properly
installed earthed socket.
• In case a new socket is needed, installation and cable connection must only be
done by a quali fied electrician. If the plug is no longer accessible following
installation, a pole disconnecting device must be present on the installation site with
a contact gap of at least 3 mm.
• Adapters, multiway strips and extension cords must not be used. Overloading can
result in fire.
• If the appliance is not fitted with a supply cord and a plug, the connection
equipment must have a contact separation in all poles that provide full
disconnection, and the appliance must be incorporated in the fixed wiring in
accordance with the wiring rules.
• The accessible surface may be hot during operation.
Fitted units
• This appliance is only intended to be fully fitted in a kitchen.
• This appliance is not designed to be used as a tabletop appliance or inside a
cupboard.
• The fitted cabinet must not have a back wall behind the appliance.
• A gap of at least 45 mm must be maintained between the wall and the base or
back panel of the unit above.
• The fitted cabinet must have a ventilation opening of 250 cm2 on the front. To
achieve this, cut back the base panel or fit a ventilation grille.
• Ventilation slots and intakes must not be covered.
• The safe operation of this appliance can only be guaranteed if it has been installed
in accordance with these installation instructions.
• The fitter is liable for any damage resulting from incorrect installation.
• The units into which the appliance is fitted must be heat-resistant up to 90 °C.
Electrical connection
The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket. Only a qualified electrician who takes the approriate regulations
into account may install the socket or replace the connecting cable. If the plug is no
longer accessible following installation, an all-pole isolating switch must be present on
the installation side with a contact gap of at least 3 mm. Contact protection must be
ensured by the installation.
Fuse protection: see instructions for use-technical data.
EN
49