Operating Determinations - EuroLite AB-616-R Bedienungsanleitung

Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it.
The total weight of the installation (=total weight of all individual parts) must never exceed the maximum load
of the alubar.
The stand must only be installed on a plane area with a maximum inclination angle of 5°.
Caution: Stands may cause severe injuries when crashing!
When using stands under the influence of horizontal forces, e.g. through wind, the standing safety can be
impaired. This is why additional safety measures like attaching ballast weights have to be taken.
If inclined tension cables or prolonged outriggers are used, the area of danger has to be marked or even be
blocked.
Before lifting or lowering the telescopic tubes, you must alway block a safety area around the stand. This
safety area must have a diameter of 1.5 times the maximum height.
Lifted telescopic tubes always have to be secured with a secondary securing!
If the alubar will be installed at a trussing system or be suspended, it must always be secured with an
appropriate safety-rope!
All devices, lighting effects and crossbeams attached on the alubar must be secured with an appropriate
safety-rope!
Before taking into operation, every stand has to be checked upon possible damages.
If one part of a stand is defective, the stand must not be taken into operation.
Keep away children and amateurs!

3. OPERATING DETERMINATIONS

This device is a fundamental part for installing e.g. spotlights or lighting effects. This product is only allowed
to be operated with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
The maximum carrying capacity of this holding device must never be exceeded.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
12/18 00026015.DOC, Version 1.1