Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.1 Installation on a stand
If the Alubar will be installed on a manually driven stand, the maximum carrying capacity is 14 kg!
Install the fundamental part at the top of the stand and tighten the screw.
Carefully pull out the stand.
5.2 Installation on a trussing system
Caution: Trussing installations may cause severe injuries when crashing down! If you have doubts
concerning the safety of a possible installation, do NOT install the trussing!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the
installation's weight.
For suspending crossbeams, Alu-Bars, etc. always use a minimum of two hooks.
Attach the upper fixation of a C-hook to the crossbeam and tighten the fixation screw. Attach the Alubar to
the lower fixation of a C-hook and tighten the fixation screw.
16/18
00026015.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
