Personnel Qualification; Personal Protective Equipment; Labelling, Safety Marks - WIKA CTD9100-1100 Betriebsanleitung

3. Safety
Don't touch the probe to calibrate when it's in the block.
■
After using wait for the stabilization at ambient
■
temperature before switch off the calibrator.
Don't switch off the calibrator when it works at high
■
temperature because the protection grid may overheat.
Don't put anything near the fan-exit, because of the hot air
■
when calibrator is on.
When the calibrator must to be moved, remove the sleeve
■
and the ceramic top insulation.
Never put any type of liquid inside the block.
■

3.5 Personnel qualification

WARNING!
Risk of injury should qualification be
insufficient!
Improper handling can result in considerable
injury and damage to equipment.
The activities described in these operating
instructions may only be carried out by skilled
personnel who have the qualifications described
below.
Skilled personnel
Skilled personnel, authorised by the operator, are understood
to be personnel who, based on their technical training,
knowledge of measurement and control technology and
on their experience and knowledge of country-specific
regulations, current standards and directives, are capable
of carrying out the work described and independently
recognising potential hazards.
Special operating conditions require further appropriate
knowledge, e.g. of aggressive media.

3.6 Personal protective equipment

The personal protective equipment is designed to protect the
skilled personnel from hazards that could impair their safety
or health during work. When carrying out the various tasks
on and with the instrument, the skilled personnel must wear
personal protective equipment.
Follow the instructions, displayed in the work area,
regarding personal protective equipment!
The required personal protective equipment must be
provided by the operating company.
Wear protective gloves!
Protect hands from contact with hot surfaces.
WIKA operating instructions, model CTD9100-1100

3.7 Labelling, safety marks

Product label (example)
The product label is fixed on the rear of the instrument.
8
7
6
5
4
3
Year of manufacture
1
Fuse
2
Notes regarding the safety data sheet
3
Serial no.
4
Power supply
5
6 Temperature range
7 Model designation
Instrument designation
8
Explanation of symbols
Before mounting and commissioning the
instrument, ensure you read the operating
instructions!
Do not dispose of with household waste. Ensure
a proper disposal in accordance with national
regulations.
EN
1
2
7