Transport; Packaging And Storage; Commissioning, Operation; Operating Position - WIKA CTD9100-1100 Betriebsanleitung

5. Transport, packaging and storage / 6. Commissioning, operation
5. Transport, packaging and storage

5.1 Transport

Check the temperature dry-well calibrator for any damage
that may have been caused by transport.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage
to property can occur.
▶ When unloading packed goods upon delivery
as well as during internal transport, proceed
carefully and observe the symbols on the
packaging.
▶
With internal transport, observe the
instructions in chapter 5.2 "Packaging and
storage".
If the instrument is transported from a cold into a warm
environment, the formation of condensation may result
in instrument malfunction. Before putting it back into
operation, wait for the instrument temperature and the room
temperature to equalise.

6. Commissioning, operation

Personnel: Skilled personnel
Protective equipment: Protective gloves
Only use original parts (see chapter 13 "Accessories").
WARNING!
Physical injuries and damage to property
and the environment caused by hazardous
media
Upon contact with hazardous media (e.g.
oxygen, acetylene, flammable or toxic
substances), harmful media (e.g. corrosive,
toxic, carcinogenic, radioactive), and also with
refrigeration plants and compressors, there is
a danger of physical injuries and damage to
property and the environment.
Should a failure occur, aggressive media and/
or with high temperature may be present at the
instrument.
▶ For these media, in addition to all standard
regulations, the appropriate existing codes or
regulations must also be followed.
▶
Wear the requisite protective equipment.
WIKA operating instructions, model CTD9100-1100

5.2 Packaging and storage

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection
during transport (e.g. change in installation site, sending for
repair).
Permissible conditions at the place of storage:
Storage temperature: -10 ... +60 °C [14 ... 140 °F]
■
Humidity: 30 ... 95 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down
■
hard)
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable
■
atmospheres
Store the temperature dry-well calibrator in its original
packaging in a location that fulfils the conditions listed above.

6.1 Operating position

The operating position of the temperature dry-well calibrator
is in the vertical orientation, since this guarantees an optimal
temperature distribution in the metal block.
The calibrator is only for indoor use.
Voltage supply
DANGER!
Danger to life caused by electric current
Upon contact with live parts, there is a direct
danger to life.
▶
Only ever use the supplied mains cable (see
chapter 4.5 "Voltage supply").
The voltage supply of the instrument is made via the power
cable. This is included in the scope of delivery.

6.2 Switching on the calibrator

1. Connect to the mains using the mains connector supplied.
2. Switch on the mains switch.
EN
11