Mantis ComposT-Twin Benutzerhandbuch Seite 54

GB
L
!
SAFETY WARNING
COMPOSTER DRUM IS VERY HEAVY -
BE CAREFUL WHEN LIFTING. AT LEAST
TWO PEOPLE ARE NEEDED TO LIFT DRUM AND POSITION
ON SUPPORT FRAME.
Step 41
Lift the drum assembly and position on the bottom
frame. Adjust gears and middle wheels so that gear
teeth mesh with the corresponding end cap teeth, and
the middle divider edge fits into the middle wheel
groove.
Position the
breather cap (key
No. 15) on
the inside of
the door (key No.
17), over the
breather screen.
Place the tip of the
cap's boss inside the
hollow part of the
screen's boss. Hold
breather cap and
attach these two
parts with self-
tapping screw using
Phillips head
screwdriver. Apply some pressure on the screw head to
start thread cutting operation. Repeat this step and
assemble breathers at all four locations.
Step 45
Close door using latches.
54
L
!
Step 43
Put self-tapping screw (key No. 26) into the
cavity in the middle of the breather cap. Be sure that
the screw's tip is coming out of the hole. Place the
breather screen (key No.16) on the front side of the
door, covering the round opening.
Step 44
Hold door horizontally and fit door hooks through the
openings above the door panel. Close the doors on
the drum to cover door opening and check the
position of the breather screens.
TO REMOVE DOOR:
1. Unlatch both latches
2. Open door slightly
3. Slide door up into the
drum and rotate.
4. Pull to remove door.
5. Do not bend the door
hooks while removing the
door.
ComposT-Twin Panel
Door Hook
DOOR
CLOSED
Your ComposT-Twin is now completely
assembled! Please read operating
instructions before use.
Step 42
Step 46
Hooks
To open, slide door up
and rotate - then pull to
remove