Mantis ComposT-Twin Benutzerhandbuch Seite 51

Vent hole
Step 21
Correct assembly of the body of the first chamber is
very important. Beginning at the arrow located inside
the end cap, position the rib of the 1st panel (key No.
19) in the alignment slot. Bend the panels
counterclockwise with ribs inside (the vent opening in
the end cap should be across from the door opening,
2nd panel (key No. 18)).
Step 23
L
SAFETY WARNING
!
DO NOT TIGHTEN BOLTS - THEY SHOULD
SPIN FREELY! SLOTS WILL ACCOMMODATE THE
EXPANSION OF MATERIAL DURING
TEMPERATURE CHANGES
Find the two sets of mounting holes on
the drum's 3rd panel (key No. 20) of the first chamber.
Attach latches (key No. 24) to the panel using screws
(key No. 27), flat washer
(key No. 28) and Keps nut
(key No. 29), as shown.
Door opening
(key No.18)
First panel
(key No.19)
L
!
Step 25
L
!
SAFETY WARNING
USE CARE IN HANDLING THE THREADED RODS. BE
SURE TO USE THE DISPOSABLE RED PROTECTIVE
COVERS FOR YOUR SAFETY IN ASSEMBLING THE
COMPOSTER.
Continue to fit the edge of the sheet metal into the
opening formed by the inside edge of the end cap and
vertical ribs to form the chamber. Overlap the last
joint and align the slots. Fasten the last joint using
shoulder bolts (brass coloured, key No. 30), nylon
insert lock nuts (key No. 31), Phillips head screwdriver
and 3/8" (10 mm) wrench.
Step 24
To attach the door latch (key No. 24), make sure that
the hook part of the latch is pointing up towards the
door panel.
Step 26
Place the four threaded rods inside the sheet metal
chamber, and into the four round openings found in the
L
!
Step 22
end caps.
GB
51