Mantis ComposT-Twin Benutzerhandbuch Seite 47

Step 10
Slide the other end of the axle rod through the
corresponding guide so that the axle rod is supported
by the guides.
Step 12
Choose the corner for the handle (this decision is
entirely up to you). Place the end of the handle
assembly inside the axle rod at that corner, and align
the holes of the handle and axle rod. Gently drive
spring pin (key No.11) through the holes using a
hammer or rubber mallet.
Step 14
Gear pin opening
Pin hole in axle
rod
Step 11
Make sure that the gear pin opening faces the pin
hole in the axle rod tubing. Repeat these steps 8-10
for the second axle rod.
Step 13
Drive the spring pins through the holes in the three
other corners of the frame. The spring pin should
extend an equal amount on each side of the axle rod.
Line up the pin opening in the gear (key No.7) with
the corresponding pin and slide the gear over it.
Repeat this step with each gear. TIGHTEN ALL NUTS
AND BOLTS SECURELY.
The support frame for your
Mantis ComposT-Twin is ready!
Place the frame on level ground, where you want the
composter to be located in your garden. Lubricate the
four axle rod guide sections with wheel bearing
grease.
L
! SAFETY WARNING
A SLANTED OR UNEVEN POSITION CAN MAKE THE
LOADED COMPOSTER UNSTABLE AND HARDER TO
TURN. BE SURE TO PLACE THE SUPPORT FRAME ON
LEVEL GROUND
GB
L
!
47