Mantis ComposT-Twin Benutzerhandbuch Seite 46

GB
Step 4
Place upper supports (key No.3) in a position where
the smaller leg of the upper support slides into the
wider leg of the lower support, and the wider leg of
the upper support slides into the smaller leg of the
lower support, as shown. Slide the ends of the upper
support tubing fully into and over the lower support
section. Repeat this step on the other end.
10
Step 6
Slide plastic grip (key No.9) over the handle
(key No.8). Be sure that pin hole is on the
opposite end of the handle.
Step 8
Slide one end of the axle rod (key No.5) into the axle
rod guide of the upper support assembly.
46
Slide together
9
8
Pin hole
Step 5
Fasten the long spacers (key No.4) to the upper
support on both sides using 2" (5.08 cm) shoulder
bolts (key No.12). Tighten fully.
Step 7
Place the push cap nut (key No.10) over the handle
and tap it on with a hammer or rubber mallet. Put
handle assembly aside for now.
7
Step 9
Slide one gear (key No.7), one centre support wheel
(key No.6), and another gear onto the axle rod in the
order shown.
7
6