Mantis ComposT-Twin Benutzerhandbuch Seite 52

GB
Step 27
The divider has the words "DOOR" printed on the
inside. Line up the words with the door opening
panel. Pick up the divider and guide it so the
threaded rods slip through the four openings in the
divider.
Step 29
Place the disposable red
protective covers (key No.
33) on one end of each
threaded rod.
Step 32
Pick up the sheet metal assembly of
the second chamber and place it on
top of the divider to align with the
door of the first chamber.
52
Step 30
Holding the threaded rods and the end
of the chamber, tilt the chamber on its
side. Thread an acorn nut onto the
exposed thread on the outside of the
end cap. Repeat this step with
all four threaded rods.
Step 33
Bend the assembly with the ribs
inside and fit the edge of the
sheet metal into the opening
formed by the inside edge of the
divider and the vertical ribs. Door
openings should be located side
by side.
Step 28
Fit the rim of the divider over the open edge of the
sheet metal chamber, tapping to secure in place.
Step 31
Holding the threaded rods and
the end of the chamber, lift the
chamber to rest on the end cap
once more.
Step 34
Overlap the last joint and align the slots.
Fasten the last joint using shoulder bolts
(brass coloured, key No. 30), nylon insert
lock nuts (key No. 31), Phillips head
screwdriver and 3/8" (10 mm) wrench.