Drum Assembly - Mantis ComposT-Twin Benutzerhandbuch

Find the two sets of mounting holes on the drum's 3rd
panel (key No. 20) of the second chamber. Attach latches
(key No. 24) to the panel using screws (key No. 27), flat
washer (key No.28) and nut (key No. 29), as shown. Make
sure that the hook part of the latch is pointing up towards
the door panel.
Step 37
Position the second end cap over the open end of the
drum assembly, so the four round openings align with
the four threaded rods, and making sure that the vent
hole lines up with the vent hole in the other end cap.
Fit the end cap rim over the edge of the sheet metal
assembly, making sure that the threaded rods slip
through the end cap holes.
Step 39
On the support frame, check axle rod
gears and middle wheels; be sure that
pins are inside of the pin openings of
the gears, and that the wheels are in the middle of the
axle rods.
Step 35
Place 1/4" flat washer (key No. 32) over each
threaded rod and thread an acorn nut (key No. 25)
onto the end of each rod. Tighten acorn nuts using
7/16" (11 mm) socket wrench.
Step 40
Check the door position before placing the drum on
the bottom support frame. The door openings should
be on the same side of the bottom frame as the
handle, and latches should be on the bottom part of
the door opening.
Step 36
Remove the disposable red protective
covers from the end of each threaded
rod and discard.
Step 38
GB
53